GALAX GTX 1050 Ti EXOC White Synthetic Benchmark Results
For the synthetic benchmarks, I used some of the most popular benchmarking tools, namely: 3DMark Sky Diver, 3DMark Fire Strike (with Extreme and Ultra), 3DMark Time Spy for DX12, Unigine Valley and Heaven. Below are the results:
Next page, let’s see how the Galax GTX 1050 Ti EXOC White performs on the widely used 1080p gaming resolution.
does fan stops at idle?
no, the fans don’t stop at idle
use msi afterburner and it should accept the fan profile you can setup.
so far i’ve only seen seen 1070 (and higher) that would not let you drop to 0% manually.
sometimes the manufacturer only uses FE profile or might just lock it to a certain min rpm,
but so far, all sub 1070 cards i setup can be throttled on the fan to any number.
i usually run a min rpm that keeps all fans spinning at lowest number they allow (without stopping)
till 50C, then jump to stock profile rpm till 60C, and max fan speed at 100C.
monitor temps for max levels in afterburner, if you hit +82C set endpoint to 5C less and see if its enough.
try to stay below 84 as max temp, unless you turn up temp and power limit in afterburner,
which would also allow the card to boost higher (without manually adding oc).
just make sure you have decent airflow, and this card will most likely clock +2ghz