GALAX GeForce GTX 1050 Ti EXOC White 4GB Review


GALAX GTX 1050 Ti EXOC White 1440p Benchmark Results

For the 1440p gaming tests, I used the same settings with the 1080p. All games are set to their highest graphics presets (Ultra or Very High) and graphics resolution is set to 2560×1440. Note that the GeForce GTX 1050 Ti isn’t designed for 1440p gaming and above. Many games are still playable at this resolution but you definitely need to lower the graphics quality to get playable frame rates. I wouldn’t recommend a 1050 Ti if you are planning to play at this resolution. To give you an ideal check out the results below.

Finally, let’s see how the GTX 1080 Mini performs on the 2160p or 4K UHD gaming resolution.

You might also like
  1. Rafael Lim Brillo says

    does fan stops at idle?

    1. Jeff says

      no, the fans don’t stop at idle

    2. Frank Honest says

      use msi afterburner and it should accept the fan profile you can setup.
      so far i’ve only seen seen 1070 (and higher) that would not let you drop to 0% manually.
      sometimes the manufacturer only uses FE profile or might just lock it to a certain min rpm,
      but so far, all sub 1070 cards i setup can be throttled on the fan to any number.

      i usually run a min rpm that keeps all fans spinning at lowest number they allow (without stopping)
      till 50C, then jump to stock profile rpm till 60C, and max fan speed at 100C.
      monitor temps for max levels in afterburner, if you hit +82C set endpoint to 5C less and see if its enough.
      try to stay below 84 as max temp, unless you turn up temp and power limit in afterburner,
      which would also allow the card to boost higher (without manually adding oc).
      just make sure you have decent airflow, and this card will most likely clock +2ghz

Leave A Reply

Your email address will not be published.

fourteen − 1 =